Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites

Authors

  • Jingyue Zhang School of Shandong Jiaotong University, Jinan 250000, China

DOI:

https://doi.org/10.54691/ahhn1e43

Keywords:

Si6.5Fe Fe-Si alloy powder; HDPE; filling ratio; yield strength; density; contact angle; Izod notched impact.

Abstract

To meet the demands of corrosion resistance, light weight, certain load-bearing capacity and ballast for PE-boat applications, high-density polyethylene (HDPE, Formosa 9001, extrusion grade) was used as the continuous phase and Si6.5Fe Fe-Si alloy powder as the functional filler. Under a fixed baseline hot-pressing process (200 °C, holding pressure for 15 min, 10–15 MPa, staged venting), five composites with powder-to-HDPE mass ratios of 2:8, 3:7, 4:6, 5:5 and 6:4 were prepared, and their tensile yield and fracture performance, density, water contact angle and Izod notched impact strength were tested. Results show that as the filling ratio increases, the mean yield strength decreases from 23.38 MPa to 18.68 MPa, the actual fracture force from 789.76 N to 694.96 N, density rises monotonically from 1.13 g/cm³ to 1.95 g/cm³, the contact angle rises from 67.21° to a peak of 75.57° at 5:5 and then falls back to 74.54°, and the Izod notched impact strength decreases from 10.98 kJ/m² to 7.20 kJ/m². All five ratios exceed the 17 MPa yield-strength threshold, and the measured density agrees closely with the rule-of-mixtures value, indicating good compactness. The study provides an experimental basis for selecting the optimal filling ratio and for subsequent hot-pressing process optimization.

Downloads

Download data is not yet available.

References

[1] GB/T 1040. (n.d.). Plastics — Determination of tensile properties. Standardization Administration of China.

[2] GB/T 1843-2008. (2008). Plastics — Determination of Izod impact strength. Standardization Administration of China.

[3] GB/T 1033.1-2008. (2008). Plastics — Methods of determining density, Part 1: Immersion method, liquid pycnometer method and titration method. Standardization Administration of China.

[4] GB/T 30693-2014. (2014). Plastics film and sheet — Measurement of water contact angle. Standardization Administration of China.

[5] GB/T 9341-2008. (2008). Plastics — Determination of flexural properties. Standardization Administration of China.

[6] GB/T 3960-2016. (2016). Plastics — Sliding friction and wear test method. Standardization Administration of China.

[7] GB/T 30142-2013. (2013). Measuring method for shielding effectiveness of planar electromagnetic shielding materials. Standardization Administration of China.

Downloads

Published

19-11-2026

Issue

Section

Articles

How to Cite

Zhang, J. (2026). Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites. Frontiers in Science and Engineering, 6(11), 32-38. https://doi.org/10.54691/ahhn1e43